Chevy Dana 60 Truss

Description Chevy Dana 60 Truss Our Chevy Dana 60 Truss kit fits Chevy Dana 60 kingpin front axles. The Truss is roughly only 1″ taller than the top of the differential allowing for more clearance and easy link mounting.  We wanted you to be able to fit the truss under a wide multitude of rigs while giving it a “cool” factor and being functional. With a truss you’ll not only be reinforcing axle strength but this will additionally allow you to upgrade to custom suspension to fit your rigs goals. You will be required to remove the factory spring perches and other factory brackets in order to install the truss. Assembly is quick because of the keyed & slotted design. We quality check every truss before they go out the door to ensure great fitment. At Offroad Anonymous we wanted the trusses to be stout, so the truss uprights are made from 3/16″ steel & top is made from 1/4″ steel. We leave the truss as raw steel to allow you to match the color scheme of your rig. Our Upper Link Brackets fit like a glove on the truss! We also offer a large selection of Rod Ends and Link Tabs. We also offer a Chevy Dana 60 Low Profile Truss if you want a slimmer look. Special Notes: *Chevy KP 60 – Roughhousing measurements – Short side tube about 4.375″/ Long side tube about 22.75″ / Center section 18.375″ *This kit requires welding and fabrication skills. Only tackle the welding yourself if you’re an experienced welder. *Offroad Anonymous implies no guarantees or warranties & is not liable for improper installation. *You will find that grinding & fitment may be required while installing the kit. Axles vary slightly from the manufacture; fabrication required. *Additional Shipping Fee Applies/ Can not ship to PO Boxes